The Mechanical Triaxial Jointmeter is designed to measure movement in three axes across any joint, be it a construction joint in concrete or a tension crack in rock.
The Mechanical Triaxial Jointmeter is designed to monitor three way displacement (X, Y and Z) across joints or cracks between adjoining concrete and rock structures. The Jointmeter comprises two elements; a zinc coated measurement arm and a Stainless Steel reference head, both attached to reinforcing bar embedment anchor stems. The measurement arm incorporates three orthogonal locating bushes, designed to receive a mechanical or electronic micrometer. The Stainless Steel reference head is a cubic anvil, with precision machined reference faces, providing a surface against which the triaxial displacement measurements are made. Manual measurement with a mechanical gauge is a more preferred option when fewer readings are required. |
|
Product Features |
|
Product Benefits |
|
Operation |
The arm anchor stems are embedded at either side of the joint, crack or fissure to be monitored, either in wet concrete at a construction joint, or grouted firmly into drilled holes in a pre-existing mass or structure, using cementatious or chemical grouts.
A temporary, removable jig maintains the two halves of the jointmeter in correct alignment at its mid-range, until the embedment medium has gained sufficient strength to be able to fully support the jointmeter. Readings are acquired by recording the current distance from the measurement bushes to the reference anvil in X, Y and Z planes. The current readings are then subtracted from an initial base reading to give relative movement of the joint or crack. |
Application |
The Mechanical Triaxial Jointmeter is used for the measurement of X, Y and Z dimensional relative movement between two abutted structures or masses.
Typical applications include:
|
Technical Rating |
As the correct installation of any monitoring sensor or system is vital to maximise performance and accuracy, Geomotion makes the following recommendations for the skill level of the installation contractor.
Technical Rating for this Product: BASIC As a minimum the installer has read and fully comprehends the manual, and if possible has observed these instruments or systems being installed by others. Geomotion offer installation and monitoring services to support this system. For more information please contact us. |
Company |
Geomotion Malaysia
No 23-1 (First Floor), Jalan Puteri 4/6, Bandar Puteri 47100 Puchong, Selangor Darul Ehsan, Malaysia T: +60 3 8066 3757 T: +60 3 8066 3535 E: [email protected] |
© COPYRIGHT 2020 ALL RIGHTS RESERVED.
|
Website by RRMS
|